2/11/2023 0 Comments Cetus3d software crash![]() The printer will buzz and the print head will start to extrude. About ve minutes, the temperature of the print head will reach the melting temperature, e.g. Choose PLA or the material you choose from the dropdown material list, and input the lament weight. Click the "Maintenance" button in the software. Raise the platform slightly.ġ3 Cetus3D Preparing for Printing Make sure the printer switched on and connected to a computer. No resistance is felt at all when moving the paper. Can feel some resistance when moving paper. The nozzle is pinning the paper onto the platform. Then set the nozzle height to 178.5 1 2 3 4 The print head is too low. For example: If the print head position determined by the paper is 179. When the correct distance is obtained, note the value of current print head position, deduct 0.5mm from the value, and click the "Set" button to set it as the Nozzle Height. Refer to the figure at the bottom of this page. There should be a slight resistance but the paper could be moved freely. Move the paper back and forth to feel the drag between the nozzle and the platform. Use the + and - buttons to adjust the print head to just touching the paper. Put a piece of paper in between the nozzle and the platform. Use the + button to lower the print head to close proximity of platform. Press button 5 to move print head to the middle of the build platform. Precautions Warning label on printer: High Temperature, do not touch! Warning label on printer: Moving Parts, do not touch! 1 2 3 4 5 6 7ġ2 Cetus3D Setting the Nozzle Height 1. Users are recommneded to discharge any static charge from the body before touching the machine to prevent interruption of printing and any potential damage to the printer. The Cetus's ideal working temperature is between 15☌ and 30☌ with relative humidity between 20–50%. The USB cable can be unplugged after the data transfer is nished. When the UP software is sending data to the printer-indicated on the status bar on the left bottom corner of the software interface with the text "sending layers"-do not unplug the USB cable as this will disrupt the data transfer and result in a printing failure. We also suggest you put the printer in an environment with a stable temperature as unwanted cooling could cause adverse eects to the print quality. Run the printer in a well-ventilated environment. When printing with ABS or PLA, the plastics will generate a slight odor. ![]() Do not touch these parts while they are moving. During printing, the nozzle and the print platform could be moving at high speeds. Wear goggles when removing the supporting material from models, or detaching models from the print board. Do not touch these parts with your bare hands while they are hot-not even with the heat resistant gloves included with the machine-as the temperature could damage the gloves and injure your hands. During printing, the temperature of the nozzle of Cetus could reach 260☌ and the print platform could reach 100☌. Keep the power adapter away from water and high temperature environments. 4 Cetus3D Cetus 3D printer only works with the power adapter provided by the original manufacturer, otherwise the machine could become damaged or even cause a re hazard.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |